S611 Soft Starter MN03902011E—May 2012 www.eaton.com 45Motor Protection/Advanced Programming Set PointsThe basic operation of the S611 is fully programmable through dedicated Protection andOperation LEDs (P/O LEDs). More advanced settings are available indirectly (throughparameter codes) by selecting the Operation mode and the Advanced Config parameter.The following diagram outlines the procedure for editing the advanced set points of the S611.See table on Page 41 in Appendix A—Parameters for advanced parameters.Note: The editing mode can be exited at any time (without saving the parameter value) usingthe Mode/Cancel button.Motor Protection/Advanced Programming Set PointsStep 1: Press Mode button until Operation mode LED is lit.Step 2: Press Up or Down button until Advanced Param P/O LED is lit.Display shows the current parameter code.Step 3: Press the Edit/Save button. The display now shows the parameter codebut it is now flashing.Step 5: Press the Edit/Save button. The display now shows the parameter valuecorresponding to the selected parameter code. The value will be flashing asediting is enabled.Mode/CancelStep 4: Use the Up/Down buttons to select the desired parameter.P. 10P. 10P. 20Edit/SaveEdit/SaveStep 6: Use the Up/Down buttons to select the desired parameter value.Step 7: Press the Edit/Save button to store the new parameter value.140120www.comoso.com