RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 6-21Changing to the Static IP Address ModeStep Procedure1 Select the Network link from any web page of the Printer.2 Select the Use the following IP address radio button, which prepares thePrinter to use network settings (that the User has manually set).These manual settings will then be used the next time the Printer is rebooted.3 Enter the network settings which are required for Ethernet communicationsfrom within the same subnet.With only these entries the User cannot print from a subnet (other than onthe subnet on which the Printer is connected). These required settings arethe following:• IP Address• Subnet Mask4 Enter the optional network settings for Ethernet communications across arouter from other subnets, as follows:• Default Gateway5 Enter the optional network settings for DNS. These are the following:• DNS Server Address• DNS Domain Suffix6 Select the Submit button to save these changes to stored settings in thememory of the Printer. (Note: These settings will not be lost if the power isremoved from the Printer.)Continued on the next page
