RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 3-1Section 3: Installation ProceduresSafety Messages (review carefully)Symbol Critical Procedures for Safety purposesDanger: Failure to follow these installation guidelines can result in death orserious injury.Information that raises potential safety issues is indicated by a warningsymbol (as shown to the left).• To prevent personal injury, refer to the following safety messagesbefore performing an operation preceded by this symbol.• To prevent personal injury, always remove the power cord prior toperforming repair procedures, unless otherwise specified.Caution: This device is electrostatically sensitive. It may be damaged ifexposed to static electricity discharges.Information that raises potential electrostatic safety issues is indicated bya warning symbol (as shown to the left).• To prevent equipment or media damage, refer to the followingsafety messages before performing an operation preceded by thissymbol.• To prevent equipment or media damage, observe all establishedElectrostatic Discharge (ESD) procedures while handling cables in ornear the Circuit Board and Printhead Assemblies.• To prevent equipment or media damage, always wear anappropriate personal grounding device (e.g., a high quality wrist strapgrounded to avoid potential damage).• To prevent equipment or media damage, always remove theRibbon and Cards from the Printer before making any repairs, unlessotherwise specified.• To prevent equipment or media damage, take jewelry off of fingersand hands, as well as thoroughly clean hands to remove oil anddebris before working on the Printer.
