RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 4-1Section 4: Accessory ProceduresSafety Messages (review carefully)Symbol Critical Instructions for Safety purposesDanger: Failure to follow these installation guidelines can result indeath or serious injury.Information that raises potential safety issues is indicated by awarning symbol (as shown to the left).• To prevent personal injury, refer to the following safetymessages before performing an operation preceded by thissymbol.• To prevent personal injury, always remove the power cordprior to performing repair procedures, unless otherwisespecified.Caution: This device is electrostatically sensitive. It may be damaged ifexposed to static electricity discharges.Information that raises potential electrostatic safety issues isindicated by a warning symbol (as shown to the left).• To prevent equipment or media damage, refer to thefollowing safety messages before performing an operationpreceded by this symbol.• To prevent equipment or media damage, observe allestablished Electrostatic Discharge (ESD) procedures whilehandling cables in or near the Circuit Board and PrintheadAssemblies.• To prevent equipment or media damage, always wear anappropriate personal grounding device (e.g., a high quality wriststrap grounded to avoid potential damage).• To prevent equipment or media damage, always remove theRibbon and Cards from the Printer before making any repairs,unless otherwise specified.• To prevent equipment or media damage, take jewelry off offingers and hands, as well as thoroughly clean hands to removeoil and debris before working on the Printer.
