RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 3-5Module Installation ProceduresInstalling the Output Module AccessoryParts included: Output Module Accessory Kit, Torx tool and screwsTools needed: Torx Tool (included in kit)Estimated Repair Time: 20 minutesStep Procedure1Caution: Power off the Printer by unplugging the power cord fromthe Printer.2 Remove all USB, Serial, and Ethernet communication connections. Removethe Card Output Hopper.Important: Do not remove the Covers for this procedure.3 The Output Module is installed at the output side of the Printer.4 a. Turn the Printer and the Output Module on their back.b. Use the Torx tool provided to remove the two (2) screws from the bottomof the Output Module. Save the screws for later for reattachment.5 If the Printer Module has the Output Side Upgrade Cover installed, thenfollow the Removing the Output Side Upgrade Cover (if applicable)procedure (provided below these instructions).6 Position the Output Module attachment tabs into the appropriate slots at thebase of Printer. See Display A (below).7 Use the two (2) screws to attach the Output Module to the Printer. Pleaserefer to the pictures below.Continued on the next page
