RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 6-59Restoring the Factory Settings for EthernetThere may be times when you are unable to use the current configuration of the Ethernetinterface. (Note: This could be because you have lost the password for your Printer or youjust cannot get it to work properly.)Resetting the settingsThe has a menu selection that allows the User names and passwords to revert to default. Toreset these settings, select:Menu: Setup Printer : Network Settings : Reset Passwords.Changing the LCD Network SettingsThe Printer/encoder will display new menu entries when (a) the Ethernet option is installedand (b) the Printer has established communications to a host device.• You can use these procedures to change network settings by using the new LCD menus.Accessing the Network Setup MenuStep Procedure1 Apply power to the Printer.2 Ensure that the Printer is connected to your network.3 Wait up to one (1) minute to allow the Printer to configure the IP address.4 Select Options on the LCD.5 Select Menu on the LCD.6 Select the Next button on the LCD until the Network Settings menu entryappears.7 Press Select when Network Settings appears on the LCD.
