RESTRICTED USE ONLY Fargo Electronics, Inc.HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1) 6-60Changing the DHCP SettingStep Procedure1 See the Accessing the Network Setup Menu procedure to access theNetwork Settings menu :Options -> MENU -> Next -> Network Settings2 Select Next on the LCD to view the DHCP menu entry.• DHCP Enabled indicates that the automatic IP assignment is selected.• DHCP Disabled indicates that the static IP assignment is selected.3 Press the Change button to switch the DHCP setting.4 If you change the setting, you will be prompted to reboot the Printer.Changing the ANEG settingThe ANEG status indicates the current setting of the network configuration of the Ethernetinterface.• This value can be set explicitly by the User to force the Ethernet interface configuration incases where auto negotiation fails.• Failure of the automatic network configuration can cause slow data transmission, longerprint times or network connection problems.Follow the procedure provided below.Step Procedure1 See the Accessing the Network Setup Menu procedure to access theNetwork Settings menu (Options ->Menu -> Next -> Network Settings).2 Select Next on the LCD to view the ANEG: menu entry.3 Press the Change button to change the auto negotiation setting for thePrinter, which will rotate between the following:• ANEG: AUTO: Allows the auto negotiation between the Printer and thehost Ethernet interface.• ANEG: Full Dup: Forces the full duplex communications between thePrinter and the host Ethernet interface.• ANEG: Half Dup: Forces the half duplex communications between thePrinter and the host Ethernet interface.4 If you change the setting, you will be prompted to reboot the Printer.
