CHAPTER 4: INTERFACES FRONT PANEL INTERFACEB30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL 4-434• PHASE C — LED 13 — Indicates phase C was involved• NEUTRAL/GROUND — LED 14 — Indicates that neutral or ground was involved4.2.5 Front panel labelling4.2.5.1 Enhanced front panelThe following procedure requires these pre-requisites:• The UR front panel label cutout sheet (GE part number 1006-0047) has been downloaded fromhttp://www.gegridsolutions.com/products/support/ur/URLEDenhanced.doc and printed• Small-bladed knifeTo create custom LED and pushbuttons labels for the enhanced front panel:1. Start the EnerVista UR Setup software.2. If not already copied to the Offline Window area, right-click the online device and select the Add Device to OfflineWindow option. Click the Receive button in the window that opens to save the settings file to the Offline Window area.3. Type labels as follows. Select the File > Front Panel Report. The window opens.Figure 4-52: Enhanced front panel label designer4. Enter the text to appear next to each LED and above each user-programmable pushbutton in the fields provided. TheLED Offsets and Button Offsets buttons move all labels left/right and up/down on the page (they both do the sameaction, so use either button). The Button Offsets button does not display when there are no pushbuttons to customize.5. Feed the UR front panel label cutout sheet into a printer and press the Print button in the front panel report window.6. When printing is complete, fold the sheet along the perforated lines and punch out the labels.7. Remove the UR label insert tool from the package and bend the tabs as described in the following procedures. Thesetabs are used for removal of the default and custom LED labels.
