CHAPTER 6: ACTUAL VALUES RECORDSB30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL 6-236This menu displays the user-programmable fault report actual values. See the User-Programmable Fault Report section inchapter 5 for information on this feature.6.5.2 Event records6.5.2.1 Enhanced and standard front panelsACTUAL VALUES RECORDS EVENT RECORDSThe event records menu shows the contextual data associated with up to the last 1024 events, listed in chronologicalorder from most recent to oldest. When all 1024 event records have been filled, the oldest record is removed as a newrecord is added. Each event record shows the event identifier/sequence number, cause, and date/time stamp associatedwith the event trigger. See the COMMANDS CLEAR RECORDS menu for clearing event records.Only major output operands generate events, not every operand. Elements that assert output per phase, for example, logoperating phase output only without asserting the common three-phase operand event.See also the system log (syslog) information in the previous chapter.The event records are also viewable in the software and in a web browser. The figure shows the event records in thesoftware. To view them in a web browser, enter the IP address of the device. When an oscillography icon displays, click it toopen it.Figure 6-6: Event records viewed in EnerVista software EVENT RECORDS EVENT: XXXXXX Date and time stamps EVENT: 3POWER ON EVENT 3DATE: 2000/07/14 EVENT: 2POWER OFF EVENT 3TIME: 14:53:00.03405 EVENT: 1EVENTS CLEARED