5-30 B30 BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUALPRODUCT SETUP CHAPTER 5: SETTINGS5Figure 5-7: Rolling mode settingsRolling Mode DelayRange: 0 to 900 s in steps of 1Default: 300 sSet this delay to 0 to disable the rolling mode feature.Otherwise, after no pushbutton has been pressed for the amount of time specified by this setting, the displayautomatically enters rolling mode. While in the rolling mode, the Rolling Mode Pages display. Rolling mode can beinterrupted when a setting changes, such as changing the home page, then resumes rolling.Automatic Annunciator RecallRange: Enabled, DisabledDefault: EnabledWhen Enabled, an annunciator window changes state, and the display is in rolling mode, this setting terminates rollingmode and displays the annunciator page containing the changed state.The Configurable Navigation feature takes precedence over this setting when the Automatic Annunciator Recall andConfigurable Navigation are activated by the same input.Screen Saver DelayRange: 0 to 900 s in steps of 1Default: 300 sThe screen saver mode extends the life of the display. After the amount of time set here, the screen saver activates andthe display intensity is reduced to the level set by the Screen Saver Intensity setting. When in rolling mode, rollingcontinues while the screen saver is active. The screen saver terminates when rolling mode terminates. To disable thescreen saver, set the delay to 0.Screen Saver IntensityRange: 0, 10, 20, or 30 %Default: 30 %This setting sets the brightness of the display while the screen saver is active. For example, 0% means that the screen isdark and nothing displays. Pressing a pushbutton or changing a setting in the software, for example, re-activates thedisplay.Number of Rolling Mode PagesRange: 1 to 10 in steps of 1Default: 1This setting specifies the number of rolling pages. During rolling mode, the graphical front panel displays pages from 1to the selected number.
