7 - 8 Genie Z-45/22 Part No. 32960Service Manual - Second EditionSection 7 - Repair ProceduresPLATFORM CONTROLSDesired resultcontinuity (zero Ω)no continuity (infinite Ω)no continuity1-3Foot SwitchHow to Test the Foot Switch1 Turn the keyswitch to theoff position anddisconnect the wiring quick disconnect plugfrom the platform toe board.2 Do not press down the foot switch. Connect theleads from an ohmmeter or continuity tester toeach wire connector combination listed belowand check for continuity.Testred to blackred to whiteblack to whiteDo not use the colors of theconnector as a guide for thesetests. Use the actual wire color toidentify which contact to use fortesting.3 Press down the foot switch. Connect the leadsfrom an ohmmeter or continuity tester to eachwire connector combination listed below andcheck for continuity.Testred to blackred to whiteblack to white1-4ResistorsTwo resistors are used to maintain proper controlof drive speeds. Both resistors are located in theplatform control box.How to Test the Resistors1 Turn the keyswitch to the off position and setthe drive mode select switch to high range(two-wheel symbol).2 Connect the leads from an ohmmeter to eachend of the resistor being tested.3 Compare the ohmmeter reading with theresistance rating printed on the resistor.Desired resultno continuity (infinite Ω)no continuitycontinuity (zero Ω)800-610-4101ActionRental.com
