Part No. 32960 Genie Z-45/22 7 - 35Service Manual - Second Edition Section 7 - Repair ProceduresGROUND CONTROLS8-2Toggle SwitchesSee 1-4,Toggle Switches.8-4ResistorsHow to Test the ResistorsTwo resistors are used to maintain proper controlof boom function speeds. A 10 ohm resistorreduces voltage to all the boom function switches.A 15 ohm resistor parallels the 10 ohm resistor toreduce the voltage to the turntable rotate switch.Turn the key switch to theoffposition and remove the key.1 Disconnect one of the resistor wires from theresistor or the opposite end terminal.2 Connect the leads from an ohmmeter to eachend or wiring of the resistor being tested.3 Compare the ohmmeter reading with theresistance rating printed on the resistor.8-3Wago® ComponentsHow to Remove a Wago®ComponentElectrocution hazard. Contact withhot or live circuits may result indeath or serious injury. Removeall rings, watches and otherjewelry.A small standard screw driver isprovided and should be usedwhen removing a Wago®component. This screwdriver islocated in the instruction manualstorage box in the platform.1 Label and then disconnect the wiring from thecomponent to be removed.2 Locate the removal tab on the bottom or topside of the component.3 Use the provided screwdriver to gently pry upon the tab of the component and remove it.800-610-4101ActionRental.com
