Part No. 32960 Genie Z-45/22 7 - 51Service Manual - Second Edition Section 7 - Repair Procedures13-1Yoke and HubHow to Remove the Yoke/HubAssembly1 Remove the cotter pin, and the clevis pin fromboth the steering cylinder and tie rod weldment.a axleb pin retainerc king pind yokee hubf cotter and clevis ping steering cylinderh tie rod2 Break loose the wheel lug nuts. Do not removethem.3 Block the non-steering wheels and place alifting jack under the steering axle.4 Raise the machine and place blocks under thechassis.5 Remove the lug nuts, then the tire and wheelassembly.6 Remove the pin retainer attached to the kingpin.7 Place a second jack under the yoke/hubassembly.8 Use a soft metal drift to drive the king pin downand out.Crushing hazard. The yoke/hubassembly will fall when the kingpin is removed if it is not properlysupported.Always use a new cotter pin whenre-installing a clevis pin.How to Remove the Hub andBearing1 Loosen the wheel lug nuts. Do not removethem.2 Place a lifting jack under the steering axle.3 Raise the machine and place blocks under thechassis.4 Remove the lug nuts, then the tire and wheelassembly.5 Remove the dust cap, cotter pin and slottednut.6 Pull the hub from the spindle. The washer andouter bearing should fall loose from the hub.7 Place the hub on a flat surface and gently prythe bearing seal out of the hub. Remove therear bearing.abdceghff2WD Steering Axle Components800-610-4101ActionRental.com
