Part No. 32960 Genie Z-45/22 4 - 15Service Manual - Second Edition Section 4 - Scheduled Maintenance ProceduresTABLE B PROCEDURESB-10Check the Oil Levelin the Torque HubsFailure to maintain proper torque hub oil levelsmay cause the machine to perform poorly andcontinued use may cause severe componentdamage.1 Drive the machine to rotate the hub until theside plugs are located one on top and the otherat 90 degrees.2 Remove the plug located at 90 degrees andcheck the oil level.Result: The oil level should be even with thebottom of the plug hole.3 If necessary, remove the top plug and add oiluntil the oil level is even with the bottom of theside plug hole.4 Apply pipe thread sealant to the plug, and theninstall it in the torque hub.5 Repeat this procedure for each torque hub.Drive torque hub oilCapacity 17 fluid ounces0.51 litersType: SAE 90 multipurpose hypoid gear oil - APIserviceclassification GL5B-11Check and Adjust the Engine IdleMixture - Gasoline/LPG ModelsComplete information to perform this procedure isavailable in the Ford LSG-423 2.3 Litre IndustrialEngine Service Manual (Ford number: 194-216).Genie part number 29586.B-12Check and Adjust theEngine RPMMaintaining the engine rpm at the proper settingfor both low and high idle is essential to goodengine performance and service life. The machinewill not operate properly if the rpm is incorrect andcontinued use may cause component damage.Gasoline/LPG ModelsPerform this procedure in gasolinemode with the engine at normaloperating temperature.1 Disconnect the blue/black wire from thegovernor actuator.2 Connect an rpm gauge to the engine, then startthe engine from the ground controls.Result: Carburetor low idle should be 900 rpm.Skip to step 4 if the low idle rpm is correct.800-610-4101ActionRental.com
