Part No. 32960 Genie Z-45/22 7 - 29Service Manual - Second Edition Section 7 - Repair Procedureseb cfg7-1Governor ActuatorHow to Set Up the GovernorActuator and LinkageAdjustment of the governoractuator is only necessary whenthe governor actuator or thelinkage has been replaced.1 Connect the linkage rod to the throttle plateshaft, then tighten the lock nut.2 Fasten the lock nut and clevis yoke to thelinkage rod. Do not tighten the lock nut againstthe clevis yoke.3 Loosen the fastener on the actuator arm.Rotate the actuator arm until it is at a 110degree angle to the linkage rod.Governor Actuator and Linkagea clevis yokeb linkage rodc carburetord throttle plate shafte governor actuatorf actuator shaftg actuator arm4 Position the linkage rod so that the throttle is inthe idle position. Then adjust the clevis yoke onthe linkage rod to obtain the proper length.Install the yoke onto the actuator arm andtighten the lock nut.5 With the throttle in the idle position and theactuator arm at a 110 degree angle to thelinkage, rotate the actuator shaft slightlycounterclockwise to pre-load the spring.Tighten the fastener on the actuator armwithout releasing the shaft.d110°aFord LSG 423 Engine800-610-4101ActionRental.com
