2-10z At present, the S3100 series support only the standard templates of AppleTalk and IP, the standardtemplate of IPX encapsulated in Ethernet II format, and the user-defined templates matching theEthernet II encapsulation format. Protocol templates matching 802.2/802.3 encapsulation formatsand their extended encapsulation formats are not supported on the S3100 series currently.z Because the IP protocol is closely associated with the ARP protocol, you are recommended toconfigure the ARP protocol type when configuring the IP protocol type and associate the twoprotocol types with the same port to avoid that ARP packets and IP packets are not assigned to thesame VLAN, which will cause IP address resolution failure.z When you use the mode keyword to configure a user-defined protocol template, if you set theetype-id argument for ethernetii packets to 0x0800, 0x8137, or 0x809B, the matching packets willtake the same format as that of the IP, IPX, and AppleTalk packets respectively. To prevent twocommands from processing packets of the same protocol type in different ways, the switch willprompt that you cannot set the etype-id argument for Ethernet II packets to 0x0800, 0x8137, or0x809B.Associating a Port with a Protocol-Based VLANConfiguration prerequisitesz The protocol template for the protocol-based VLAN is configured.z The port is configured as a hybrid port, and the port is configured to remove VLAN tags when itforwards the packets of the protocol-based VLANs.Configuration procedureFollow these steps to associate a port with the protocol-based VLAN:To do... Use the command... RemarksEnter system view system-view —Enter port view interface interface-typeinterface-number —Associate the port with thespecified protocol-based VLANport hybrid protocol-vlan vlanvlan-id { protocol-index [ toprotocol-index-end ] | all }RequiredBy default, a port is not associatedwith any protocol-based VLAN.Displaying Protocol-Based VLAN ConfigurationTo do... Use the command... RemarksDisplay the information about theprotocol-based VLANdisplay vlan [ vlan-id [ to vlan-id ] | all |dynamic | static]Display the protocol information andprotocol indexes configured on the specifiedVLANdisplay protocol-vlan vlan { vlan-id [ tovlan-id ] | all }Available in anyview
