1-7z If both the limit on the number of MAC address authentication users and the limit on the number ofusers configured in the port security function are configured for a port, the smaller value of the twoconfigured limits is adopted as the maximum number of MAC address authentication users allowedto access this port. Refer to the Port Security manual for the description on the port securityfunction.z You cannot configure the maximum number of MAC address authentication users for a port if anyuser connected to this port is online.Configuring the Quiet MAC Function on a PortYou can configure whether to enable the quiet MAC function on a port. When this function is enabled,the MAC address connected to this port will be set as a quiet MAC address if its authentication fails.When this function is disabled, the MAC address will not become quiet no matter whether theauthentication is failed.Table 1-5 Configure the quiet MAC function on a portOperation Command DescriptionEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure quiet MAC functionon the portmac-authenticationintrusion-mode block-macenableRequiredEnabled by default.Displaying and Debugging MAC AuthenticationAfter the above configuration, you can execute the display command in any view to display systemrunning of MAC Authentication configuration, and to verify the effect of the configuration. You canexecute the reset command in user view to clear the statistics of MAC Authentication.Table 1-6 Display and debug MAC AuthenticationOperation Command DescriptionDisplay global or on-portinformation about MACauthenticationdisplay mac-authentication[ interface interface-list ] Available in any viewClear the statistics of global oron-port MAC authenticationreset mac-authenticationstatistics [ interfaceinterface-typeinterface-number ]Available in user view
