1-12Follow these steps to configure LLDP trapping:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet interface view interface interface-typeinterface-number RequiredEnable LLDP trap sending lldp notification remote-changeenableRequiredDisabled by defaultQuit to system view quit —Set the interval to send LLDPtrapslldp timer notification-intervalintervalOptional5 seconds by defaultDisplaying and Maintaining LLDPTo do… Use the command… RemarksDisplay the global LLDPinformation or the informationcontained in the LLDP TLVs tobe sent through a portdisplay lldp local-information[ global | interface interface-typeinterface-number ]Available in any viewDisplay the informationcontained in the LLDP TLVssent from neighboring devicesdisplay lldp neighbor-information[ interface interface-typeinterface-number ] [ brief ]Available in any viewDisplay LLDP statisticsdisplay lldp statistics [ global |interface interface-typeinterface-number ]Available in any viewDisplay LLDP status of a port display lldp status [ interfaceinterface-type interface-number ] Available in any viewDisplay types of advertisableoptional LLDP TLVsdisplay lldp tlv-config [ interfaceinterface-type interface-number ] Available in any viewLLDP Configuration ExamplesBasic LLDP Configuration ExampleNetwork requirementsAs shown in Figure 1-4, the NMS and Switch A are located in the same Ethernet. An MED device andSwitch B are connected to Ethernet 1/0/1 and Ethernet 1/0/2 of Switch A.Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch Band the link between Switch A and the MED device on the NMS.
