1-9Table 1-8 Default output rules for different output directionsLOG TRAP DEBUGOutputdirectionModulesallowed Enabled/disabledSeverity Enabled/disabled Severity Enabled/disabled SeverityConsole default (allmodules) Enabled warnings Enabled debugging Enabled debuggingMonitorterminaldefault (allmodules) Enabled warnings Enabled debugging Enabled debuggingLog host default (allmodules) Enabled informational Enabled debugging Disabled debuggingTrap buffer default (allmodules) Disabled informational Enabled warnings Disabled debuggingLog buffer default (allmodules) Enabled warnings Disabled debugging Disabled debuggingSNMP NMS default (allmodules) Disabled debugging Enabled warnings Disabled debuggingEnabling system information display on the consoleAfter setting to output system information to the console, you need to enable the associated displayfunction to display the output information on the console.Table 1-9 Enable the system information display on the console:Operation Command DescriptionEnable the debugging/log/trapinformation terminal display function terminal monitor OptionalEnabled by default.Enable debugging information terminaldisplay function terminal debugging OptionalDisabled by default.Enable log information terminal displayfunction terminal logging OptionalEnabled by default.Enable trap information terminal displayfunction terminal trapping OptionalEnabled by default.Make sure that the debugging/log/trap information terminal display function is enabled (use theterminal monitor command) before you enable the corresponding terminal display function by usingthe terminal debugging, terminal logging, or terminal trapping command.Setting to Output System Information to a Monitor TerminalSystem information can also be output to a monitor terminal, which is a user terminal that has loginconnections through the AUX, VTY, or TTY user interface.
