1-7Task RemarksSetting to Output System Information to the SNMP NMS OptionalConfiguring Synchronous Information OutputSynchronous information output refers to the feature that if the system information such as log, trap, ordebugging information is output when the user is inputting commands, the command line prompt (incommand editing mode a prompt, or a [Y/N] string in interaction mode) and the input information areechoed after the output.This feature is used in the case that your input is interrupted by a large amount of system output. Withthis feature enabled, the system echoes your previous input and you can continue your operations fromwhere you were stopped.Table 1-5 Configure synchronous information outputOperation Command DescriptionEnter system view system-view —Enable synchronous informationoutput info-center synchronous RequiredDisabled by defaultz If the system information is output before you input any information following the current commandline prompt, the system does not echo any command line prompt after the system informationoutput.z In the interaction mode, you are prompted for some information input. If the input is interrupted bysystem output, no system prompt (except the Y/N string) will be echoed after the output, but yourinput will be displayed in a new line.Configuring to Display the Time Stamp with the UTC Time ZoneTo add UTC time zone to the time stamp in the information center output information, you must:z Set the local time zonez Set the time stamp format in the output direction of the information center to datez Configure to add the UTC time zone to the output informationTable 1-6 Configure to display time stamp with the UTC time zoneOperation Command DescriptionSet the time zone for the system clock timezone zone-name { add |minus } timeRequiredBy default, UTC time zone isset for the system.Enter system view system-view —
