1-4Configuring an IP address to a VLAN interfaceTable 1-3 Configure an IP address to a VLAN interface(S3100-SI)Operation Command RemarksEnter system view system-view —Configure a specified VLAN tobe the management VLAN management-vlan vlan-idRequiredBy default, VLAN 1 operates asthe management VLAN.Enter the corresponding VLANinterface viewinterface vlan-interfacevlan-id RequiredAssign an IP address to theVLAN interfaceip address ip-address { mask |mask-length }RequiredBy default, no IP address isassigned to the managementVLAN interface.z To create the VLAN interface for the management VLAN on a switch operating as the managementdevice in a cluster, make sure that the management VLAN ID is consistent with the clustermanagement VLAN ID configured with the management-vlan vlan-id command. Otherwise, theconfiguration fails. Refer to the Cluster Operation Manual for detailed introduction to the cluster.z Refer to the VLAN module for detailed introduction to VLAN interfaces.Table 1-4 Configure an IP address to a VLAN interface(S3100-EI)Operation Command RemarksEnter system view system-view —Enter VLAN interface view interface vlan-interfacevlan-id RequiredAssign an IP address to theVLAN interfaceip address ip-address { mask |mask-length }RequiredNo IP address is assigned bydefault.Displaying IP Addressing ConfigurationAfter the above configuration, you can execute the display command in any view to display theoperating status and configuration on the interface to verify your configuration.Table 1-5 Display IP addressing configurationOperation Command RemarksDisplay information about aspecified or all Layer 3 interfacesdisplay ip interface[ interface-type interface-number ] Available in any view
