3-15Configuring Source IPv6 Addresses of MLD QueriesThis configuration allows you to change the source IPv6 address of MLD queries.Follow these steps to configure source IPv6 addresses of MLD queries:To do... Use the command... RemarksEnter system view system-view —Enter VLAN view vlan vlan-id —Configure the source IPv6 addressof MLD general queriesmld-snooping general-querysource-ip { ipv6-address |current-interface }OptionalFE80::02FF:FFFF:FE00:0001 bydefaultConfigure the source IPv6 addressof MLD multicast-address-specificqueriesmld-snooping special-querysource-ip { ipv6-address |current-interface }OptionalFE80::02FF:FFFF:FE00:0001 bydefaultThe source IPv6 address of MLD query messages may affect MLD querier election within the segment.Configuring MLD Snooping ProxyingConfiguration PrerequisitesBefore configuring MLD snooping proxying in a VLAN, enable MLD snooping in the VLAN and preparethe following data:z Source IPv6 address for the MLD reports sent by the proxyz Source IPv6 address for the MLD done messages sent by the proxyEnabling MLD Snooping ProxyingThe MLD snooping proxying function works on a per-VLAN basis. After you enable the function in aVLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router inthe VLAN.Follow these steps to enable MLD snooping proxying in a VLAN:To do... Use the command... RemarksEnter system view system-view —Enter VLAN view vlan vlan-id —Enable MLD snooping proxyingin the VLAN mld-snooping proxying enable RequiredDisabled by default.
