1-15Figure 1-13 Upload file switch.btm to the switchStep 8: Configure switch.btm to be the Boot ROM at next startup, and then restart the switch. boot bootrom switch.btmThis will update Bootrom on unit 1. Continue? [Y/N] yUpgrading Bootrom, please wait...Upgrade Bootrom succeeded! rebootAfter the switch restarts, the file switch.btm is used as the Boot ROM. It indicates that the Boot ROMloading is finished.2) Loading host softwareLoading the host software is the same as loading the Boot ROM program, except that the file to bedownloaded is the host software file, and that you need to use the boot boot-loader command to selectthe host software used for the next startup of the switch.z The steps listed above are performed in the Windows operating system, if you use other FTP clientsoftware, refer to the corresponding user guide before operation.z Only the configuration steps concerning loading are listed here. For detailed description on thecorresponding configuration commands, refer to the “FTP-SFTP-TFTP” part of this manual.Remote Loading Using TFTPThe remote loading using TFTP is similar to that using FTP. The only difference is that TFTP is used toload software to the switch, and the switch can only act as a TFTP client.
