Operation Manual – LoginH3C S5100-SI/EI Series Ethernet Switches Chapter 2 Logging In Through the Console Port2-13Note:For the introduction to AAA, RADIUS, and HWTACACS, refer to the AAA part of thismanual.2.7.2 Configuration ExampleI. Network requirementsAssume the switch is configured to allow users to log in through Telnet, and the userlevel is set to the administrator level (level 3). Perform the following configurations forusers logging in through the console port (AUX user interface).z Configure the local user name as guest.z Set the authentication password of the local user to 123456 (in plain text).z Set the service type of the local user to Terminal and the command level to 2.z Configure to authenticate the users in the scheme mode.z The baud rate of the console port is 19,200 bps.z The screen can contain up to 30 lines.z The history command buffer can store up to 20 commands.z The timeout time of the AUX user interface is 6 minutes.II. Network diagramConfiguration PCrunning TelnetEthernetGE1/0/1Figure 2-8 Network diagram for AUX user interface configuration (with theauthentication mode being scheme)III. Configuration procedure# Enter system view. system-view# Create a local user named guest and enter local user view.
