Operation Manual – System Maintenance and DebuggingH3C S5100-SI/EI Series Ethernet Switches Chapter 4 Device Management4-2Note:Before rebooting, the system checks whether there is any configuration change. If yes,it prompts whether or not to proceed. This prevents the system from losing theconfigurations in case of shutting down the system without saving the configurationsUse the following command to reboot the Ethernet switch:To do… Use the command… RemarksReboot the Ethernetswitch reboot [ unit unit-id ] Available in user view4.2.3 Scheduling a Reboot on the SwitchAfter you schedule a reboot on the switch, the switch will reboot at the specified time.Follow these steps to schedule a reboot on the switch:To do… Use the command… RemarksSchedule a reboot on the switch,and set the reboot date and timeschedule reboot at hh:mm[ mm/dd/yyyy | yyyy/mm/dd ] OptionalSchedule a reboot on the switch,and set the delay time for rebootschedule reboot delay{ hh:mm | mm } OptionalEnter system view system-view —Schedule a reboot on the switch,and set the reboot periodschedule reboot regularity athh:mm period OptionalNote:The switch timer can be set to precision of one minute, that is, the switch will rebootwithin one minute after the specified reboot date and time.4.2.4 Configuring Real-time Monitoring of the Running Status of the SystemThis function enables you to dynamically record the system running status, such asCPU, thus facilitating analysis and solution of the problems of the device.
