Operation Manual – PoE-PoE ProfileH3C S5100-SI/EI Series Ethernet Switches Chapter 1 PoE Configuration1-8Table 1-11 Display PoE configurationOperation Command DescriptionDisplay the PoE status of aspecific port or all ports of theswitchdisplay poe interface[ interface-typeinterface-number ]Display the PoE powerinformation of a specific port orall ports of the switchdisplay poe interfacepower [ interface-typeinterface-number ]Display the PSE parameters display poe powersupplyDisplay the status(enabled/disabled) of the PoEover-temperature protectionfeature on the switchdisplay poetemperature-protectionAvailable in anyview1.3 PoE Configuration Example1.3.1 PoE Configuration ExampleI. Networking requirementsSwitch A is an S5100-SI/EI series Ethernet switch supporting PoE, Switch B can bePoE powered.z The GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 ports of Switch A areconnected to Switch B and an AP respectively; the GigabitEthernet 1/0/8 port isintended to be connected with an important AP.z The PSE processing software of Switch A is first upgraded online. The remotelyaccessed PDs are powered by Switch A.z The power consumption of the accessed AP is 2,500 mW, and the maximumpower consumption of Switch B is 12,000 mW.z It is required to guarantee the power feeding to the PDs connected to theGigabitEthernet 1/0/8 port even when Switch A is under full load.
