Operation Manual – LoginH3C S5100-SI/EI Series Ethernet SwitchesChapter 8 Configuring Source IP Address forTelnet Service Packets8-2II. Configuration in system viewTable 8-2 Configure a source IP address for service packets in system viewOperation Command DescriptionSpecify a source IPaddress for Telnet server telnet-server source-ip ip-address OptionalSpecify a source interfacefor Telnet servertelnet-server source-interfaceinterface-type interface-number OptionalSpecify source IP addressfor Telnet client telnet source-ip ip-address OptionalSpecify a source interfacefor Telnet clienttelnet source-interfaceinterface-type interface-number OptionalNote:To perform the configurations listed in Table 8-1 and Table 8-2, make sure that:z The IP address specified is that of the local device.z The interface specified exists.z If a source IP address (or source interface) is specified, you need to make sure thatthe route between the IP addresses (or interface) of both sides is reachable.8.3 Displaying Source IP Address ConfigurationExecute the display command in any view to display the operation state after theabove configurations. You can verify the configuration effect through the displayedinformation.Table 8-3 Display the source IP address configurationOperation Command DescriptionDisplay the source IP addressconfigured for the Telnet clientdisplay telnetsource-ipDisplay the source IP addressconfigured for the Telnet serverdisplay telnet-serversource-ipYou can execute thetwo commands in anyview.
