Operation Manual – Stack-ClusterH3C S5100-SI/EI Series Ethernet Switches Chapter 2 Cluster2-22Operation Command DescriptionClear the statistics on NDP ports reset ndp statistics[ interface port-list ]You can executethe resetcommand in userview.2.4 Cluster Configuration Example2.4.1 Basic Cluster Configuration ExampleI. Network requirementsThree switches compose a cluster, where:z An S5100 series switch serves as the management device.z The rest are member devices.Serving as the management device, the S5100 switch manages the two memberdevices. The configuration for the cluster is as follows:z The two member devices connect to the management device throughGigabitEthernet 1/0/2 and GigabitEthernet 1/0/3.z The management device connects to the Internet through GigabitEthernet 1/0/1.z GigabitEthernet 1/0/1 belongs to VLAN 2, whose interface IP address is163.172.55.1.z All the devices in the cluster share the same FTP server and TFTP server.z The FTP server and TFTP server use the same IP address: 63.172.55.1.z The NMS and logging host use the same IP address: 69.172.55.4.II. Network diagramFigure 2-4 Network diagram for HGMP cluster configuration
