Operation Manual – IPv6 ManagementH3C S5100-SI/EI Series Ethernet Switches Chapter 2 IPv6 Application Configuration2-4Figure 2-2 Provide Telnet servicesI. Configuration prerequisitesEnable Telnet on the Telnet server and configure the authentication method. For details,refer to Login Operation in this manual.Follow these steps to set up IPv6 Telnet connections:To do… Use the command… RemarksPerform the telnetcommand on the Telnetclient to log in to otherdevicestelnet ipv6 remote-system [ -iinterface-type interface-number ][ port-number ]RequiredAvailable in userviewCaution:When you use the telnet ipv6 command to connect to the Telnet server, you mustspecify the “–i” keyword if the destination address is a link-local address.II. Displaying and maintaining IPv6 TelnetTo do… Use the command… RemarksDisplay the useinformation of the userswho have logged indisplay users [ all ] Available in any view2.3 IPv6 Application Configuration Example2.3.1 IPv6 ApplicationsI. Network requirementsIn Figure 2-3, SWA, SWB, and SWC are three switches, among which SWA is an H3CS5100-SI/EI Ethernet switch, SWB and SWC are two switches supporting IPv6forwarding. In a LAN, there is a Telnet server and a TFTP server for providing Telnet
