Operation Manual – MirroringH3C S5100-SI/EI Series Ethernet Switches Chapter 1 Mirroring Configuration1-9To do… Use the command… RemarksConfigure trunk port topermit packets from theremote-probe VLANport trunk permit vlanremote-probe-vlan-id RequiredReturn to system view quit —Create a remotedestination mirroringgroupmirroring-group group-idremote-destination RequiredConfigure the destinationport for the remotedestination mirroringgroupmirroring-group group-idmonitor-port monitor-port RequiredConfigure theremote-probe VLAN forthe remote destinationmirroring groupmirroring-group group-idremote-probe vlanremote-probe-vlan-idRequiredWhen configuring a destination switch, note that:z The destination port of remote port mirroring cannot be a member port of anexisting mirroring group, a member port of an aggregation group, or a port enabledwith LACP or STP.z Only an existing static VLAN can be configured as the remote-probe VLAN. Toremove a remote-probe VLAN, you need to restore it to a normal VLAN first. Aremote port mirroring group gets invalid if the corresponding remote port mirroringVLAN is removed.1.2.3 Configuring MAC-Based MirroringNote:z The MAC address specified for MAC-based mirroring must be a static MAC addressexisting in the MAC address table.z You can configure MAC-based mirroring for a remote source mirroring group toimplement the MAC-based remote mirroring function.I. Configuration prerequisitesz The MAC address to be matched is determined.z The destination port is determined.
