Operation Manual – HWPingH3C S5100-SI/EI Series Ethernet Switches Chapter 1 HWPing Configuration1-51.2 HWPing ConfigurationThe TCP/UDP/jitter tests need the cooperation of HWPing client and HWPing server.Other types of tests need to configure HWPing client and corresponding differentservers.You can enable both the HWPing client and HWPing server functions on an H3CS5100SI/EI Ethernet switch, that is, the switch can serve as a HWPing client and serversimultaneously.1.2.1 HWPing Server ConfigurationThe following table describes the configuration on HWPing server, which is the samefor HWPing test types that need to configure HWPing server.Follow these steps to perform HWPing server configurations:To do… Use the command… RemarksEnter system view system-view —Enable the HWPingserver function hwping-server enable RequiredDisabled by default.Configure a UDPlistening servicehwping-serverudpecho ip-addressport-numRequired for UDP and jitter testsBy default, no UDP listeningservice is configured.Configure a TCPlistening servicehwping-servertcpconnect ip-addressport-numRequired for TCP testsBy default, no TCP listeningservice is configured.Note that:z The HWPing server function is needed only for jitter, TCP, and UDP tests.z You can configure multiple TCP/UDP listening services on one HWPing server,with each listening service corresponding to a specific destination IP address andport number.1.2.2 HWPing Client ConfigurationI. HWPing client configurationAfter HWPing client is enabled, you can create multiple test groups for different tests,without the need to enable HWPing client repeatedly for each test group.Different types of HWPing tests are somewhat different in parameters and parameterranges. The following text describes the configuration on HWPing client for differenttest types.
