Operation Manual – PoE-PoE ProfileH3C S5100-SI/EI Series Ethernet Switches Chapter 2 PoE Profile Configuration2-3Table 2-2 Display the PoE profile configurationOperation Command DescriptionDisplay the detailedinformation about thePoE profiles created onthe switchdisplay poe-profile { all-profile |interface interface-typeinterface-number | nameprofile-name }Available in anyview2.4 PoE Profile Configuration Example2.4.1 PoE Profile Application ExampleI. Network requirementsSwitch A is an S5100-SI/EI series Ethernet switch supporting PoE.GigabitEthernet 1/0/1 through GigabitEthernet 1/0/10 of Switch A are used by users ofgroup A, who have the following requirements:z The PoE function can be enabled on all ports in use.z Signal mode is used to supply power.z The PoE priority for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5 is Critical,whereas the PoE priority for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10is High.z The maximum power for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5ports is 3,000 mW, whereas the maximum power for GigabitEthernet 1/0/6through GigabitEthernet 1/0/10 is 15,400 mW.Based on the above requirements, two PoE profiles are made for users of group A.z Apply PoE profile 1 for GigabitEthernet 1/0/1 through GigabitEthernet 1/0/5;z Apply PoE profile 2 for GigabitEthernet 1/0/6 through GigabitEthernet 1/0/10.
