IBM eServer 240 xSeries User Reference Manual

Also see for eServer 240 xSeries: Configuration and options guide

Contents

NDIS 2.01 (OS/2) device driver messagesThis section contains the error messages for the NDIS 2.01 (OS/2) device drivers.The explanation and recommended action are included with each message.PCNTND-1 Unable to open the Protocol Manager.Explanation: The NDIS stack is not configured correctly.Action: Check and correct your configuration.PCNTND-6 Out of memory while allocating buffers.Explanation: The device driver could not allocate the requested buffers.Action: Check your system configuration. Edit the PROTOCOL.INI file to reduce the number ofTxbuffers and Rxbuffers specified for the device driver.PCNTND-7 A Protocol Manager device error occurred.Explanation: The NDIS stack is not configured correctly.Action: Check and correct your configuration.PCNTND-8 Bad status for the Protocol Manager.Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.Action: Check and correct your configuration.PCNTND-9 Cannot find the PROTOCOL.INI entry.Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.Action: Check and correct your configuration.PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.Action: Check and correct your configuration.PCNTND-11 Protocol Manager registration failed.Explanation: The NDIS stack is not configured correctly.Action: Check and correct your configuration.PCNTND-15 Device not found.Explanation: The device driver cannot find an Ethernet controller in the server.Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnosticprograms.PCNTND-16 PCI scan specified, device not found.Explanation: The device driver cannot locate the Ethernet controller on the PCI bus.Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnosticprograms.PCNTND-21 The adapter failed the checksum test.Explanation: The device driver cannot find an Ethernet controller.Action: Verify that the Ethernet controller is enabled. (See “PCI Slot/Device Information” on page 28.)If the Ethernet controller is enabled, go to “Diagnostic programs” on page 110 to run the diagnosticprograms.Chapter 6. Solving problems 139