IBM eServer 240 xSeries User Reference Manual

Also see for eServer 240 xSeries: Configuration and options guide

Contents

pnt0-17 Device fault...Reset initiated!Explanation: The SunSoft Solaris device driver has been reset because of a device fault.Action: Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters are present or replace theEthernet adapter that fails to respond. If the problem persists, go to “Diagnostic programs” on page 110to run the diagnostic programs.pnt0-19 IRQ found for PCnet hardware does not match space.c (or pnt.conf)!Explanation: This is a warning message referring to the interrupt request (IRQ) that the SunSoftSolaris device driver found in the system.Action: Ignore this message if you are sure that this is what you want to do. Otherwise, run theNETCONFIG program to match the hardware settings.pnt0-20 add_intr_handler failed! Unknown interrupt type.Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts withother devices in the server.Action: Modify your hardware settings.Run the NETCONFIG program to search for another Ethernet controller.pnt0-21 add_intr_handler failed! Out of range interrupt number.Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts withother devices in the server.Action: Modify your hardware settings.Run the NETCONFIG program to search for another Ethernet controller.pnt0-22 add_intr_handler failed! Out of range IPL.Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts withother devices in the server.Action: Modify your hardware settings.Run the NETCONFIG program to search for another Ethernet controller.pnt0-23 add_intr_handler failed! Vector already occupied.Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts withother devices in the server.Action: Modify your hardware settings.Run the NETCONFIG program to search for another Ethernet controller.pnt0-24 add_intr_handler failed! Vector already shared at different IPL.Explanation: The interrupt request (IRQ) that was specified, or the IRQ that was found, conflicts withother devices in the server.Action: Modify your hardware settings.Run the NETCONFIG program to search for another Ethernet controller.pnt0-26 The DMA number is not necessary for PCI device.Explanation: The IBM Netfinity 10/100 Fault Tolerant Adapter does not require a DMA setting.Action: Edit the SPACE.C file to delete the DMA parameter.pnt0-29 The IRQ number is already in use.Explanation: The specified I/O address is already in use.Action: Run the NETCONFIG program to modify your hardware settings.142 IBM xSeries User's Reference