Boot Device OptionsSelect this choice to configure startable device parameters. Before you canmake updates, you must know the ID of the device whose parameters youwant to configure. SCSI Device ConfigurationSelect this choice to configure SCSI device parameters. Before you can makeupdates, you must know the ID of the device whose parameters you want toconfigure.Note: When the Maximum Sync Transfer Rate is set to 80.0, this valuerepresents the transfer rate for UltraSCSI devices. When the MaximumSync Transfer Rate is set to 80.0, this value represents the transferrate for Ultra2 SCSI LVD devices. When the Maximum Sync TransferRate is set to 20.0, this value represents the transfer rate for Fast SCSIdevices. Advanced Configuration OptionsSelect this choice to view or change the settings for advanced configurationoptions. These options include enabling support for large hard disk drives andsupport for drives with UltraSCSI speed.To reset the SCSI controller defaults, press F6; then, follow the directions on thescreen.SCSI Disk UtilitiesTo see the IDs that are assigned to each SCSI device or to format a SCSI device,select SCSI Disk Utilities from the SCSISelect Utility menu.To use the utility program, select a drive from the list. Read the screens carefullybefore making a selection.Note: If the following screen appears, you might have pressed Ctrl+A before theselected drives were ready. Restart the server and watch the SCSISelectmessages as each drive spins up. After the drive that you want to view orformat spins up, press Ctrl+A.Chapter 3. Configuring your server 33
