IBM eServer 240 xSeries User Reference Manual

Also see for eServer 240 xSeries: Configuration and options guide

Contents

Installing a non-hot-plug adapterThis section contains the procedure for installing a non-hot-plug adapter. If youwant to remove a non-hot-plug adapter, reverse the steps.Before you begin: Read “Electrical safety” on page 42 and “Handling static-sensitive devices”on page 44. Read the documentation that comes with your option.Refer to the illustrations in “Installing a hot-plug PCI adapter” on page 56 while youperform the steps in this procedure.To install a non-hot-plug adapter:1. Turn off the server and peripheral devices and disconnect all external cablesand power cords (see “Preparing to install options” on page 46); then, removethe cover. See “Removing the left-side cover (tower model)” on page 48 or“Removing the cover (rack model)” on page 49.2. Determine which PCI adapter expansion slot you will use for the adapter.Note: Check the instructions that come with the adapter for any requirementsor restrictions.3. Remove the expansion-slot cover 1:a. Rotate the adapter retention latch 3 counterclockwise.b. Remove the expansion-slot cover from the server. Store it in a safe placefor future use.Attention: Expansion-slot covers must be installed on all vacant slots. Thismaintains the electromagnetic emissions characteristics of the system andensures proper cooling of system components.4. Refer to the documentation that comes with your adapter for any cablinginstructions. It might be easier for you to route any cables before you installthe adapter.5. Press on the touchpoint on the adapter retainer flap 4 at the end of the slotnearest the front of the server and rotate the adapter retainer flap upward.6. Remove the adapter from the static-protective package.Attention: Avoid touching the components and gold-edge connectors on theadapter.7. Place the adapter, component-side up, on a flat, static-protective surface.8. Set any jumpers or switches as described by the adapter manufacturer.9. Install the adapter 8:a. Carefully grasp the adapter 8 by its top edge or upper corners, and alignit with the expansion slot on the system board.b. Press the adapter firmly into the expansion slot.Attention: When you install an adapter in the server, be sure that it iscompletely and correctly seated in the system-board connector before you60 IBM xSeries User's Reference