iSeries Model 250 Packages and AS/400e Server 250104 iSeries HandbookThis feature provides a single attachment to either 16 Mbps or a 4 Mbps Token-Ring. Thefeature consists of an IOA card, internal code that supplies IEEE 802.5 Media Access Control(MAC) and IEEE 802.2 Logical Link Control (LCC) functions. The IOA is capable of operatingin half or full duplex mode.The #2724/#9724 comes with an 2.44m Token-Ring cable, or a separately purchasedtwisted-pair cable to the RJ45 connection on the IOA may be attached. It occupies one PCIcard slot.If the #2724/#9724 16/4 Mbps Token-Ring LAN IOA is installed on an #2866 IntegratedNetfinity Server, then one Specify #0220 (Token-Ring on Integrated Netfinity Server) isrequired for each #2724/#9724 ordered.The #9724 is mutually exclusive with #9723 and #9738 as a base LAN controller.#2723/#9723 PCI Ethernet IOA (10 Mbps)The #9723 is a base LAN option on the Model 250.This feature provides a single attachment to one Carrier Sense Multiple Access/CollisionDetect Local Area Network. It consists of an adapter card and internal code, which suppliesEthernet Version 2 and IEEE 802.3 Media Access Control (MAC) plus 802.2 Logical LinkControl (LLC) functions. The Ethernet/IEEE 802.3 IOA is capable of operating in half or fullduplex mode.The #2723/#9723 has an RJ45 connector and a 15-pin D-shell connector for attachment ofcustomer-supplied cabling. A vendor AUI Ethernet cable or RJ45 twisted-pair cable must beordered separately. RJ45 cabling for 10 Mbps must be CAT-3 or CAT-5, if CAT 5 is used, becausethen it meets or exceeds Industry Standard EIA/TIA T568A or T568B. It occupies one PCI cardslot.If #2723/#9723 Ethernet IOA is selected to be run on an #2866 Integrated Netfinity Server,one Specify #0221 (Ethernet on Integrated Netfinity Server) is required for each #2723/#9723ordered.The #9723 is mutually exclusive with #9724 and #9738 as a base LAN controller.#2815 PCI 155 Mbps Unshielded Twisted Pair ATM IOAThis feature allows the AS/400 system to be attached to an Asynchronous Transfer Mode(ATM) network using the Unshielded Twisted Pair (UTP-5) interface. This interface is intendedfor connection to both local area switches and direct connection to service providerequipment. The #2815 is typically used where 155 Mbps speeds are required over distancesof less than 100 meters. It uses one high-speed slot, but cannot be placed in the BaseSystem Unit. It attaches in slot E08 and slot E03 (where #2824 is a prerequisite) of the
