iSeries Model 840198 iSeries HandbookRemote Control PanelThe #0382 Remote Control Panel Cable enables use of the Remote Control Panel functionon a PC. The iSeries servers use a parallel interface (LPT) instead of a COM port for theRemote Control Panel. The parallel port must be configured to use the Enhanced ParallelPort (EPP) support. It must be EPP Version 1.9 compliant, which may require the PC's BasicInput/Output Services (BIOS) to change. Check with your PC manufacturer for anyassistance, if needed. For cable connection details and PC requirements, see theAS/400Operations Console Setup Guide , which is available at:http://www.as400service.ibm.com/supporthome.nsf/Document/10000051Notes:• Due to the way EPP Version 1.9 support is implemented to support the remote controlpanel, there may be PCs that do not support the use of this function.• Use of the Remote Control Panel function is independent of the System Console.• The Remote Control Panel function can be used with any System Console Specify.• The Remote Control Panel Cable is not required for a LAN attached console (#5546 or#5548).Remote Control Panel is installed and used from PCs running the Windows NT 4.0 orWindows 2000 Professional PC operating systems.I/O Processor and I/O Adapter SupportThis section lists the supported IOPs and IOAs. See “I/O Processor” on page 277 and “I/OAdapters and Controllers” on page 291 for full descriptions.LAN/WAN/Workstation IOAs• #2743 PCI 1 Gbps Ethernet IOA• #2744 PCI 100 Mbps Token Ring IOA• #2760 PCI 1Gbps Ethernet UTP IOA• #2772 Dual WAN/Modem Adapter• #2773 Dual WAN/Modem Adapter• #2805 PCI Quad Modem IOAPCI configuration rules for V5R1 hardware are quite flexible. See the “PCI Card PlacementRules” chapter of theiSeries and AS/400e System Builder, SG24-2155, for rules forplacing PCI card in configurations.Note
