iSeries Server 270 127iSeries Server 270Refer to Informational APAR II11804 for additional details regarding workstationconsiderations when attached devices or cabling do not support 5250 Express Data Stream.Additional information on 5250 Express Data Stream is available on the Web at:http://www.networking.ibm.com/525/The IBM 7299 twinax-to-fiber multiplexer fully supports all the new functions of the #2720,#2722, #2746, #4746, and #6180 workstation controllers.Remote Control Panel#0382 Remote Control Panel Cable enables use of the Remote Control Panel function on aPC. The iSeries servers use a parallel interface (LPT) instead of a COM port for the RemoteControl Panel. The parallel port must be configured to use the Enhanced Parallel Port (EPP)support. It must be EPP Version 1.9 compliant, which may require the PC's BasicInput/Output Services (BIOS) to change. Check with your PC manufacturer for anyassistance, if needed. For cable connection details and PC requirements, see theAS/400Operations Console Setup Guide , which is available at:http://www.as400service.ibm.com/supporthome.nsf/Document/10000051Notes:• Due to the way EPP Version 1.9 support is implemented to support the remote controlpanel, there may be PCs that do not support the use of this function.• Use of the Remote Control Panel function is independent of the System Console.• The Remote Control Panel function can be used with any System Console Specify.• The Remote Control Panel Cable is not required for a LAN attached console (#5546 or#5548).Remote Control Panel is installed and used from PCs running the Windows NT 4.0 orWindows 2000 Professional PC operating systems.I/O Processor and I/O Adapter SupportThe following list shows the supported IOPs and IOAs. See “I/O Processor” on page 277 and“I/O Adapters and Controllers” on page 291 for full descriptions.PCI configuration rules are quite flexible. See the “PCI Card Placement Rules” chapter oftheiSeries and AS/400e System Builder, SG24-2155, for rules on placing the PCI card inconfigurations.Note