142SETTING A FREQUENCY2 Tuning step selection[Tuning steps are the minimum frequency change incrementswhen you rotate [DIAL] or push [Y]/[Z] on the microphone.Independent tuning step for the left and right, as well as eachfrequency bands can be set for individual tuning convenience.The following tuning steps are available.• 5 kHz • 10 kHz • 12.5 kHz • 15 kHz• 20 kHz • 25 kHz • 30 kHz • 50 kHzNOTE: For convenience, select a tuning step that matchesthe frequency intervals of repeaters in your area.q Push the desired band’s [MAIN•BAND] to select the mainband.• Push the same band’s [V/MHz•SCAN] to select VFO mode, ifnecessary.w Push [SET• ] to enter set mode.ePush [SET• ] or [LOW•PRIO] several times until “tS” ap-pears as shown below.rRotate the same band’s [DIAL] to select the desired tuningstep.tPush [TONE•DTMF] to exit set mode.z Push [BAND] to select the desired band (left orright) as the main band.• Push [VFO/LOCK] to VFO mode, if necessary.x Push [SET B(D-OFF)] to enter set mode.c Push [SET B(D-OFF)] or [ENT C(T-OFF)] severaltimes until “tS” appears.v Push [Y] or [Z] to select the desired tuning step.b Push [CLR A(MW)] to exit set mode.SETBMAINT XMPush [SET• ][LOW•PRIO]
