457 SCAN OPERATION Scan resume conditionThe scan resume condition can be selected as timer or pausescan. The selected resume condition is also used for prioritywatch. (p. 47)q Push [MAIN•BAND] to select the desired band (left or right)as the main band.w Push [SET• ] to enter set mode.e Push [SET• ] or [LOW•PRIO] several times until “SCt”or “SCP” appears as shown above.• When “d” is displayed in place of the 100 MHz digit, cancel theDTMF memory encoder in advance. (p. 50)r Rotate the main band’s [DIAL] to set the desired timer:• “SCt-15” : Scan pauses 15 sec. while receiving a signal.• “SCt-10” : Scan pauses 10 sec. while receiving a signal.• “SCt-5” : Scan pauses 5 sec. while receiving a signal.• “SCP-2” : Scan pauses until the signal disappears and thenresumes 2 sec. later.t Push [TONE•DTMF] to exit set mode.z Push [BAND] to select the desired band (left orright) as the main band.x Push [SET B(D-OFF)] to enter set mode.c Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] severaltimes until “SCt” or “SCP” appears as shown atleft.v Push [Y] or [Z] to select the scan resume condi-tion.• See item r at left for scan resume condition details.b Push [CLR A(MW)] to exit set mode.SETBMAINT XMThe display shows that thescan will resume 15 sec. afterit stops.USING SET MODE
