29MEMORY OPERATION5 General descriptionThe transceiver has 212 memory channels including 10 scanedge memory channels (5 pairs), and 2 call channels. Each ofthese channels can be individually programmed with operatingfrequency (pgs. 11–13), duplex direction (p. 23) and offset(p. 27), subaudible tone encoder or tone squelch and its tonefrequency (pgs. 23, 25, 52, 53) and skip information* (p. 44).In addition, a total of 10 memory banks, A to J, are availablefor usage by group, etc.*except for scan edge memory channels. Memory channel selectionD Using the tuning dialq Push the desired band’s[M/CALL(MW)] severaltimes to select memorymode.• “M” indicator appearsw Rotate the same band’s[DIAL] to select the de-sired memory channel.• Programmed memorychannels only can be se-lected.D Using the [Y]/[Z] keysz Push [BAND] to select the desired band asthe main band.x Push [MR/CALL] to select memory mode.c Push [Y] or [Z] to select and set the desiredmemory channel.• Pushing [Y]/[Z] for 1 sec. activates a scan.• If scan is activated, push [Y]/[Z] again or push[ CLR A(MW)] to stop it.D Using the keypadz Push [BAND] to select the desired band asthe main band.x Push [MR/CALL] to select memory mode.c Push [ ENT C(T-OFF)] to activate the keypadfor numeral input.v Push 3 appropriate digit keys to input a chan-nel number.• Blank channel can be selected.• Push only 1 appropriate digit key, [MONI 1(BANK)],[ SCAN 2(T-SCAN)], [ PRIO 3(PTT-M)],[ HIGH 4(DTCS)] or [ MID 5(DTCSS)] then push[MM(TONE-1)] or [SQLZ #(16KEY-L)] to select scanedge channels. “MM” and “#” can be used for “A”and “b” respectively.MR/CALLY/ZMR/CALLY/ZMAINT XMPush [M/CALL•MW] to selectmemory mode.“!” appears

quick reference guide

using the mounting bracket

battery connection

antenna installation

i repeater operation

I Front panel— controller

panel description

I Function display

main unit

I Microphone (HM-133)

I Microphone keypad

I Optional microphones (HM-118N/TN/TAN)

I Preparation

setting a frequency

I Using the tuning dial

I Tuning step selection

I Lock functions

I Receiving

I Squelch attenuator

I V/V, U/U simultaneous receive (Para-watch)

I Sub band mute/sub band busy beep

I Transmitting

I One-touch PTT function

I General

I Accessing a repeater

repeater operation

I Subaudible tones

I Offset frequency

I General description

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

memory operation

I Memory clearing

I Memory bank selection

I Memory bank setting

I Transferring bank contents

I Call channel selection

I Programming a call channel

I Scan types

I Scan start/stop

I Scan edges programming

scan operation

I Skip channel setting

I Scan resume condition

I Priority watch types

I Priority watch operation

I Programming a DTMF code

dtmf memory encoder

i transmitting a dtmf code

I DTMF speed

I Pocket beep operation

tone scan

other functions

I Initial set mode

I AM/FM narrow mode

i weather channel operation

I Microphone keys

I Packet operation

I Troubleshooting

I Fuse replacement

I Speciﬁcations

I Options

mode arrangement

Icom IC-2720H Instruction Manual

IC-2720

IC-2720H