519 DTMF MEMORY ENCODERD Manual transmissionz Deactivate the DTMF memory encoder bypushing [FUNC] then [SET B(D-OFF)].x Push [DTMF-S] to turn the DTMF direct selec-tion ON.• The function indicator (microphone) lights green.c Push one of “0” to “9” and “A” to “F” keys mo-mentarily, then push the desired DTMF keys,0–9 and A to F.• A: [CLR A(MW)] B: [ SET B(D-OFF)],C: [ENT C(T-OFF)] D: [ SQLY D(MUTE)],E: [MM(TONE-1)] F: [ SQLZ #(16KEY-L)]• Automatically transmits without pushing PTT.• The first code, one of “A” to “F,” is not transmitted.DTMF code transmission starts from the 2nd code.v Push [DTMF-S] again to deactivate the DTMFdirect selection. DTMF speedThe rate at which DTMF memories send individual DTMFcharacters can be set to accommodate operating needs.q Push [PWR] for 1 sec. to turn power OFF.w While pushing [SET• ], push [PWR] for 1 sec. to turnpower ON and enter initial set mode.e Push [SET• ] or [LOW•PRIO] several times until “dtd”appears as shown above.r Rotate the left band’s [DIAL] to select the desired speedas shown in the table below.t Push [PWR] to exit initial set mode.cps=characters/secMAINT XMThe display shows the fastestDTMF speed is selected.USING INITIAL SET MODEDTMF-SDISPLAY INTERVAL SPEEDdtd-- 1 100 msec. 5.0 cpsdtd-- 2 200 msec. 2.5 cpsdtd-- 3 300 msec. 1.6 cpsdtd-- 5 500 msec. 1.0 cps
