305MEMORY OPERATION5 Programming a memory channel[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the controller.MAINT XMMAINT XMMAINT XMMAINT XMMAINT XMMAINT XMPush Rotate for setting frequency, etc. Push for 1 sec.Rotate Push for 1 sec. and continue to push ➠S.MWMWBeep“BeepBeepBeep“““““BeepBeepBeep“““““SCANV/MHz MWM/CALLVFO settings, including the set mode contents such as sub-audible tone frequency, offset, can be programmed into amemory channel.qSet the desired frequency in the desired band (left or right).➥ Push the desired band’s [V/MHz•SCAN] to select VFOmode.➥ Set the frequency using the same band’s [DIAL].➥ Set other data (e.g. tone frequency, duplex information,etc.) if required.w Push the same band’s [M/CALL•MW] for 1 sec.• 3 beeps sound• “!” indicator and the memory channel number blink.eRotate the [DIAL] to select the memory channel to be pro-grammed.• Memory channels not yet programmed are blank.r Push the [M/CALL•MW] for 1 sec. to program.• 3 beeps sound• Memory channel number automatically increases when contin-uing to push [M/CALL•MW] after programming.✔CONVENIENTMemory programming can be performed in versatile wayse.g. memory channel to the same (or different) memory chan-nel, memory channel to the call channel, etc.
