396 CALL CHANNEL OPERATION Programming a call channelOperating frequency, duplex information, subaudible tone in-formation (tone encoder or tone squelch ON/OFF and its fre-quency) can be programmed into the call channel.q Set the desired frequency in VFO mode.➥ Push the desired band’s [V/MHz•SCAN] to select VFOmode.➥ Set the frequency using the same band’s [DIAL].➥ Set other data as desired.w Push the same band’s [M/CALL•MW] for 1 sec.e Rotate the [DIAL] to select the desired call channel.• “!” indicator and “C1” or “C2” blink.r Push the [M/CALL•MW] for 1 sec. to program.• 3 beeps sound and the unit returns to VFO mode automatically.z Set the desired frequency in VFO mode.➥ Push [VFO/LOCK] to select VFO mode.➥ Set the frequency.➥ Set other data as desired.x Push [FUNC], then [CLR A(MW)] momentarily.c Select the call channel via [Y] or [Z] .v Push [FUNC] then [CLR A(MW)] for 1 sec. toprogram.• 3 beeps sound and the unit returns to VFO modeautomatically.MR/CALLMW[Y]/[Z][EXAMPLE]: Programming 145.120 MHz into the call channel 2 via the microphone.MAINT XMMAINT XMMAINT XMMAINT XMMAINT XMMAINT XMSet the frequency.Push to select VFO mode. Push , then .Push , then push for 1 sec. ➠Push until large “C” appears.BeepBeepBeep“““““
