71 PANEL DESCRIPTION Microphone keypadKEY FUNCTION SECONDARY FUNCTION ( +key) OTHER FUNCTIONSSwitches between opening and closing thesquelch. (p. 13)Starts and stops scanning. (p. 38)Starts and stops priority watch. (p. 44)Selects high output power. (p. 15)Selects mid. output power. (p. 15)Selects low output power (p. 15)Selects minus duplex operation. (p. 18)Selects plus duplex operation. (p. 18)Selects simplex operation. (p. 18)No primary function.In memory mode switches the channel namesor number indication ON and OFF. (p. 31)Starts and stops tone scanning. (p. 51)Turns the one-touch PTT function ON andOFF. (p. 16)Turns the DTCS squelch ON. (p. 50)Turns the DTCS pocket beep function ON.(p. 49)Turns the DTMF memory encoder functionON. (p. 45)Turns the subaudible tone encoder ON.(p. 18)Turns the CTCSS pocket beep functionON. (p. 49)Turns the tone squelch function ON.(p. 50)Sends a 1750 Hz tone signal while pushingand holding. (p. 20)After pushing :Transmits the appropriateDTMF code. (pgs. 20, 46)When the DTMF memory en-coder is activated, push [0] to[9] to transmit the appropriateDTMF memory contents .(p. 46)

quick reference guide

battery connection

antenna installation

i repeater operation

I Front panel

I Function display

I Rear panel

I Microphone (HM-133V)

I Microphone keypad

I Preparation

I Using the keypad

I Tuning step selection

I Lock functions

I Receiving

I Audio mute function

I Transmitting

I One-touch PTT function

I Accessing a repeater

repeater operation

I Subaudible tones

I Offset frequency

i reversed duplex mode

I Auto repeater

I General description

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

memory operation

I Memory clearing

i programming channel names

I Memory bank selection

I Memory bank setting

I Transferring bank contents

I Call channel selection

I Programming a call channel

I Scan types

I Scan start/stop

I Scan edges programming

I Skip channel setting

I Scan resume condition

I Priority watch types

I Priority watch operation

I Programming a DTMF code

i transmitting a dtmf code

I DTMF speed

I Pocket beep operation

tone scan

I Code programming

I Pager operation

other functions

I Initial set mode

i weather channel operation

i microphone keys

I Partial reset

I Data cloning

I Troubleshooting

i fuse replacement

I Optional unit installation

specifications and options

mode arrangement

Icom IC-V8000 Instruction Manual

RECEIVER CIRCUITS

MAIN UNIT

PLL CIRCUITS

HM-133V

LOGIC BOARD

IC-V8000

ANI FUNCTION

Preparation

Operation

voice scrambler

explicit definitions

panel description

i function display

i rear panel

i microphone keypad

using the mounting bracket

i battery connection

i antenna installation

setting a frequency

i using the keypad

i tuning step selection

i lock functions

basic operation

i audio mute function

i selecting output power

subaudible tones

d frequency range and offset direction

repeater lockout

i programming a memory channel

i programming a memory channel via the microphone

i transferring memory contents

i memory clearing

i memory bank selection

i memory bank setting

call channel operation

i programming a call channel

scan operation

i scan edges programming

i skip channel setting

i scan resume condition

priority watch

i priority watch operation

dtmf memory encoder

transmitting a dtmf code

i dtmf speed

pocket beep and tone squelch