17REPEATER OPERATION4 Accessing a repeaterq Set the receive frequency (repeater output frequency).(pgs. 9, 10)w Push [LOW(DUP)] for 1 sec., one or two times, to selectminus duplex or plus duplex.• “–” or “+” appears to indicate the transmit frequency for minusshift or plus shift, respectively.• When the auto repeater function is turned ON (available for theUSA and CSA versions), steps w and e are not necessary.(p. 23)e Push [TONE(T-SCAN)] several times to turn ON the sub-audible tone encoder, according to repeater requirements.• “ ” appears• 88.5 Hz is set as the default; refer to p. 19 for tone frequency set-tings.• When the repeater requires a different tone system, see p. 20.r Push and hold [PTT] to transmit.• The displayed frequency automatically changes to the transmitfrequency (repeater input frequency).• If “OFF” appears, confirm that the offset frequency (p. 21) is setcorrectly.t Release [PTT] to receive.yPush [MONI(ANM)] to check whether the other station’stransmit signal can be received directly.uTo return to simplex operation, push [LOW(DUP)] for1 sec., once or twice, to clear the “–” or “+” indicator.iTo turn OFF the subaudible tone encoder, push [TONE(T-SCAN)] several times until no tone indicators appear.While transmittingWhile receiving.Appears[TONE(T-SAN)]Either “–” or “+” appears.[LOW(DUP)]

quick reference guide

battery connection

antenna installation

i repeater operation

I Front panel

I Function display

I Rear panel

I Microphone (HM-133V)

I Microphone keypad

I Preparation

I Using the keypad

I Tuning step selection

I Lock functions

I Receiving

I Audio mute function

I Transmitting

I One-touch PTT function

I Accessing a repeater

repeater operation

I Subaudible tones

I Offset frequency

i reversed duplex mode

I Auto repeater

I General description

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

memory operation

I Memory clearing

i programming channel names

I Memory bank selection

I Memory bank setting

I Transferring bank contents

I Call channel selection

I Programming a call channel

I Scan types

I Scan start/stop

I Scan edges programming

I Skip channel setting

I Scan resume condition

I Priority watch types

I Priority watch operation

I Programming a DTMF code

i transmitting a dtmf code

I DTMF speed

I Pocket beep operation

tone scan

I Code programming

I Pager operation

other functions

I Initial set mode

i weather channel operation

i microphone keys

I Partial reset

I Data cloning

I Troubleshooting

i fuse replacement

I Optional unit installation

specifications and options

mode arrangement

Icom IC-V8000 Instruction Manual

RECEIVER CIRCUITS

MAIN UNIT

PLL CIRCUITS

HM-133V

LOGIC BOARD

IC-V8000

ANI FUNCTION

Preparation

Operation

voice scrambler

explicit definitions

panel description

i function display

i rear panel

i microphone keypad

using the mounting bracket

i battery connection

i antenna installation

setting a frequency

i using the keypad

i tuning step selection

i lock functions

basic operation

i audio mute function

i selecting output power

subaudible tones

d frequency range and offset direction

repeater lockout

i programming a memory channel

i programming a memory channel via the microphone

i transferring memory contents

i memory clearing

i memory bank selection

i memory bank setting

call channel operation

i programming a call channel

scan operation

i scan edges programming

i skip channel setting

i scan resume condition

priority watch

i priority watch operation

dtmf memory encoder

transmitting a dtmf code

i dtmf speed

pocket beep and tone squelch