5211PAGER/CODE SQUELCH1011 Pager functionThis function uses DTMF codes for paging and can be usedas a “message pager” to inform you of a caller’s identificationeven when you leave the transceiver temporarily unattended. Code programmingDD Before programmingThe pager and code squelch functions require ID codes and agroup code. These codes are 3-digit DTMF codes and mustbe written into the code channels before operation.q Decide the ID code of each transceiver and a group codefor your group.w Decide whether you want to return to normal operation orcode squelch operation after a connection is made.e Program the ID code, group code and transmit codes(other station’s codes) as below.DD Code channel assignment*Channel CP automatically memorizes an ID code when receiving apager call. The contents in channel CP cannot be changed manually.Optional UT-108 requiredPager selective code(push [PTT])Beep BeepBeepAnswer back (manual)Beep BeepBeepSet both transceivers toeither code squelch ornon-coded operationCommunicationOptional UT-108 requiredID OR CODE CHANNEL “RECEIVE ACCEPT” ORGROUP CODE NUMBER “RECEIVE INHIBIT”Your ID code 0 “Receive accept” onlyOther parties’ 1–6 “Receive inhibit” should beID code programmed in each channel.Group code One of 1–6 “Receive accept” must beprogrammed.Memory space* P “Receive inhibit” only.

quick reference guide

battery connection

antenna installation

i repeater operation

I Front panel

I Function display

I Rear panel

I Microphone (HM-133V)

I Microphone keypad

I Preparation

I Using the keypad

I Tuning step selection

I Lock functions

I Receiving

I Audio mute function

I Transmitting

I One-touch PTT function

I Accessing a repeater

repeater operation

I Subaudible tones

I Offset frequency

i reversed duplex mode

I Auto repeater

I General description

I Programming a memory channel

programming a memory channel via the microphone

I Transferring memory contents

memory operation

I Memory clearing

i programming channel names

I Memory bank selection

I Memory bank setting

I Transferring bank contents

I Call channel selection

I Programming a call channel

I Scan types

I Scan start/stop

I Scan edges programming

I Skip channel setting

I Scan resume condition

I Priority watch types

I Priority watch operation

I Programming a DTMF code

i transmitting a dtmf code

I DTMF speed

I Pocket beep operation

tone scan

I Code programming

I Pager operation

other functions

I Initial set mode

i weather channel operation

i microphone keys

I Partial reset

I Data cloning

I Troubleshooting

i fuse replacement

I Optional unit installation

specifications and options

mode arrangement

Icom IC-V8000 Instruction Manual

RECEIVER CIRCUITS

MAIN UNIT

PLL CIRCUITS

HM-133V

LOGIC BOARD

IC-V8000

ANI FUNCTION

Preparation

Operation

voice scrambler

explicit definitions

panel description

i function display

i rear panel

i microphone keypad

using the mounting bracket

i battery connection

i antenna installation

setting a frequency

i using the keypad

i tuning step selection

i lock functions

basic operation

i audio mute function

i selecting output power

subaudible tones

d frequency range and offset direction

repeater lockout

i programming a memory channel

i programming a memory channel via the microphone

i transferring memory contents

i memory clearing

i memory bank selection

i memory bank setting

call channel operation

i programming a call channel

scan operation

i scan edges programming

i skip channel setting

i scan resume condition

priority watch

i priority watch operation

dtmf memory encoder

transmitting a dtmf code

i dtmf speed

pocket beep and tone squelch