14 | EnglishGeneral featuresDisplay Mode SwitchingSwitching the display mode.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [3] (KDC-W8027)/ [4] (KDC-PSW9527/W9027) button.Refer to 'Notes on Multi-function Key System'(page 10).2 Enter display control modePress the [3] ("DISP") (KDC-W8027)/ [4]("DISP") (KDC-PSW9527/W9027) button.3 Select the display modePress the [2] ("MODE") button.Each time the button is pressed the displaymode switches as shown below.Display Mode Display"Display:A" 23141"Display:B" 6 54"Display:C" 6 5"Display:D" 61 Side graphic part2 Upper text display part3 Lower text display part4 Function item display5 Text display part6 Graphic & spectrum analyzer display part4 Exit display control modePress the [6] ("RTN") button.• No function item is displayed if "Display:C" or "Display:D" is selected. To use a function item, press any of [1]to [6] buttons or [NEXT] button. The function item willbe displayed approximately 5 seconds.• When the 'Dual Zone System' (page 24) is ON, thespectrum analyzer cannot be displayed.• The display is dimmed during "Display:B" or "Display:C" mode.• The indicator appears only when the Clock isdisplayed in the upper or lower position during"Display:A" mode.Display:AText Display SwitchingSwitching the text display.1 Select the key function sectionPress the [NEXT] button.Repeatedly press the button until "DISP" isdisplayed above the [3]/ [4] button.Refer to 'Notes on Multi-function Key System'(page 10).2 Enter display control modePress the [3]/ [4] ("DISP") button.3 Select the display modePress the [2] ("MODE") button.Select the "Display:A" display.4 Enter text select modePress the [3] ("TEXT") button.• In the Rotary Volume Operation mode, you can selectthe Upper part or Lower part using button [3] ("TEXT")and switch the display using the rotary volume key.5 Select the text in the upper text display partPress the [FM] or [AM] button.Select the text in the lower text display partPress the [4] or [¢] button.Refer to the table described later for settingitems.6 Exit Display Control modePress the [6] ("RTN") button.• The setting of this function is available while "Display:A" is selected for the Display mode.• Upper text display part cannot display the sameinformation as Lower text display part.• The Album name cannot be displayed during WMAplay.