Kenwood KDC-PSW9527 Instruction Manual

Also see for KDC-PSW9527: Service manual

Contents

English | 27[2] "PLII""MUSIC" (Music) [5] "FINE""MOVIE" (Movie)"MATRIX" (Matrix)[2] "PNRM"[3] "DIM"[4] "CT-WDTH"[3] "WOW""LOW" (Low)[5] "FINE""MIDDLE" (Middle)"HIGH" (High)[2] "FOCUS"[3] "TruBass-F"[3] "TruBass-R""USER" (User) [4] "SRS 3D"2nd sectionMulti-function key operation Audio control item[2] "POSI" Position setting[3] "BL/F" [3] "BL"[3] "F"Balance settingFader setting[4] "VOFF" Volume offset[5] "SW"* 2 [5] "SW LEVEL"[5] "PHASE"Subwoofer levelSubwoofer Phase setting• Volume offset: Each source’s volume can be set as adifference from the basic volume.• *2 You can control this item when 'Subwoofer Output'(page 25) is set to "SUB WOOFER ON". Note that youcan control it only when "SP-LEV" is set to any itemother than "None" by 'Audio Setup (Easy mode)'(page28).6 Adjust the Audio Control itemPress the [4] or [¢] button.Each time the button is pressed the settingswitches as shown below.1st sectionAudio Control Item RangeDolby ProLogic II setting* MUSIC/ MOVIE/ MATRIXSRS WOW setting LOW/ MIDDLE/ HIGH/ USEROFF setting Through/ BypassPanorama setting ON/ OFFDimension control R3 — R1/ Neutral/ F1 — F3Center width control 0 — 7FOCUS setting OFF/ 1 — 9SRS TruBass Front settingSRS TruBass Rear settingOFF/ 1 — 4SRS 3D setting OFF/ 1 — 42nd sectionAudio Control Item RangePosition setting ALL/ Front-L/ Front-R/ FrontBalance setting L15 — R15Fader setting R15 — F15Volume offset -8 — 0Subwoofer level -10 — +10Subwoofer Phase setting Normal/ Reverse• * Function of the KDC-PSW9527• The Adjustment item can also be controlled by therotary volume knob. Refer to 'Rotary Volume knoboperation mode select' (page 13).• When the 'Dual Zone System' (page 24) is ON, each ofthe following setup is ignored.- "WOW"/ "PLII"/ "POSI"/ "PHASE"• WOW: TruBass, FOCUS and SRS 3D are all set to valuesshown below.WOW FOCUS TruBass SRS 3DHIGH 8 4 4MIDDLE 6 3 2LOW 3 2 1• FOCUS: Adjusts the sound image by changing thevertical position of the speakers virtually andincreases or decreases the soundscape.• TruBass: Assisting the playback for the super basssound.• SRS 3D: Making a natural 3D sound field.• SRS 3D cannot be set in tuner source.• The Dimension Control can be set only when the rearspeaker is ON.• The Center Width Control can be set only when thecenter speaker is ON.• Before you set the "TruBass-F"/ "TruBass-R" to getthe best sound, set the speaker size using the 'AudioSetup (Easy mode)' (page 28) function. Refer to 'Noteson Sound Management System' (page 11).7 Exit Audio Control modePress the [6] ("RTN") button.